There may be some failures when we use the braiding machine to braid cables, and we should calmly face the failures, so it is necessary for us to master some methods to solve the failures of the braiding machine. Xuzhou braiding machine is here to share with you, how to solve the phenomenon of stopping when braiding cables.

The machine stops suddenly during the weaving process because the line is broken or the line has been used up, and it can be started to continue weaving after the corresponding disposal. Xuzhou braiding machine

During the preparation process, if it is found that the outer layer being woven does not meet the requirements, it should be stopped at any time, and the motor should be reversed to clear the weaving of the wire on this length, and then the normal weaving will be resumed after disposal.

Strictly in accordance with the process card sent to the workshop machine, control the process parameters, and make inspection records.

A complete coil requires a head to the end, if the internal joint needs to be cut, it must indicate the reason in the middle of the identification of 30cm long non-woven strip, and write the length of the previous section, such as several specifications on the plate together, should be written from the inside out of the product model, specifications, length. Xuzhou braiding machine

The lines shall be neat and tight, and there shall be no crossing of ups and downs.

Strictly in accordance with the process card sent to the workshop machine, control the process parameters, and make inspection records.

Cable is the main medium for our life and production of electricity, which plays a very important role in the composition and application of the power grid. Only by doing a good job in the quality control of the braiding machine in the cable production can we produce qualified products and reduce unnecessary losses in the later period. Xuzhou braiding machine